Download Category: ELECTRICAL ELECTRONICS ENGINEERING PROJECT TOPICS

CHAPTER ONE INTRODUCTION 1.1    BACKGROUND TO THE STUDY The use of renewable energy increased greatly just after the first big oil crisis in the late seventies. At that time, economic issues were the most important factors, hence interest in such ...

Abstract This study was on social analysis of homes near power line/mast: possible effect on residents. Three objectives were raised which included:  To determine the health effect of living close to the telecommunication masts, to determine the effect of the ...

ABSTRACT' Thermal electrical power generation is one of the major methods used in Egbin thermal station. Due to inconsistency and failure in the power supply in Nigeria, there is a need for a proper operation and maintenance schedule strategy of ...

ABSTRACT This uninterruptible power supplies device has the capability of converting from 12volts D.C to 220volts alternating current at the frequency of 50Hz with the help of a step-up transformer. The main importance of this device is its ability to ...

CHAPTER ONE INTRODUCTION 1.1     BACKGROUND OF THE STUDY This project gives the insight on the design and construction of a transmission power line vandalism detector system. Vandalism means destructive action. It is a hateful and deliberate defacement/destruction of somebody else’s ...

ABSTRACT This project deals with the construction and fabrication of a two face gas burner. The gas components consists of the following major components; burner, injector opening, mixing tube, burner support, etc. The gas stove was constructed from medium carbon ...

 ABSTRACT The Nigerian power sector is confronted with inadequate, poor, un-organized electricity billing and consumer relations management. Electricity Tariff charges and collection has been a major challenge in some community in Nigeria even with the adoption of prepaid billing meters. ...

ABSTRACT This project work is on design of a variable regulated power supply. This work describes you how to design a variable regulated power supply circuit. The main advantage of this power supply circuit is that it can vary the ...

CHAPTER ONE 1.0.  INTRODUCTION 1.1.  GENERAL DESCRIPTION OF THE PROJECT Industrial electronics has turned the whole world into a global village. One of the most indispensable aspects of these phenomena is automation, which forms the nucleus of the present day ...

 ABSTRACT A mega filling station can be described from its name –MEGA; which means larger in size. This implies that mega filling station is a large-scale fuel station outlets where fuels of various forms are sold. A typical example is ...

ABSTRACT This project is he design and construction of a voltage inverter system with trickle charging system. This device is design to provide power supply for the need of offices, household etc. In absence of NEPA power supply. It would ...

ABSTRACT Hearing aid device is a small electronic gadget that is fit in or behind the ear to improve one’s hearing and consequently communication ability.This research work involves the design and development of a hearing aid device withpre-amplifier; an acoustic ...

CHAPTER ONE GENERAL INTRODUCTION Introduction This chapter presents the introduction to the study. It presents that theoretical background, statement of the problem, aim and objectives of the study, significance of the study, scope of the study, organization of the research ...

  ABSTRACT The robot control using an RF module is simply a robotic system whose control and functioning is achieved by the use of a radio frequency based remote. This project implements the principle of artificial intelligence to develop a ...

ABSTRACT Automatic water level controller for both overhead and underground tank is designed to monitor the level of water in a tank. It displays the level of water and when it is at the lowest level; a pump is activated ...

ABSTRACT The Automatic pump control with water-level monitor and digital display is an electrical system constructed for convenient and adequate control of water into overhead tanks (OHT). The device switches “ON” automatically when the water level falls below a certain ...

PREFACE  The purpose of this text is to present at a primary and intermediate level a comprehensive over view of the construction principle and indeed the operation of a Digital Incubator.  We want to present a situation where by as ...

Abstract Installing an electrical transformer can be difficult, particularly if you are not familiar with electrical transformers or if it’s your first attempt at installing one. Electrical transformers have to be installed with the utmost care and precaution to avoid ...

  CHAPTER ONE INTRODUCTION 1.1 Background of the Study Inductive power transmission has become a more and more popular method to deliver power to mobile electronic devices and small appliances with a power consumption of up to 100W . In ...

CHAPTER ONE INTRODUCTION 1.1 Project Background Energy is a basic necessity for the economic development of a nation. There are different forms of energy, but the most important form is the electrical energy. A modern and civilized society is so ...